Can a 48V DC soldering iron connect diodes in series?
Diodes cannot be connected in series, a small resistor should be connected in series to divide the voltage. Diodes are used for rectifiers and do not have much effect on voltage division. Resistors are electronic components specially used for voltage division. First, use a multimeter to measure the resistance value of the electric soldering iron. According to this resistance value, connect an equivalent resistor in series, then the voltage distributed to the electric soldering iron will be reduced to 1/2 of the original value. If the temperature of the electric soldering iron is too low, it is not enough , You can remove this resistor and reconnect a resistor with a resistance value of 1/2 of this resistor in series, so that the voltage distributed to the electric soldering iron is 2/3 of the original. Through repeated experiments, you can find your best series resistance value.
The voltage of DC 48 volt electric appliances will be reduced by about 0.7 volts, and the reverse series connection will cut off the power supply. Note that the voltage of the diodes in series should preferably be > 65 volts, and the forward current > twice the operating current.
Ordinary diodes, depending on the model, the forward voltage drop of ordinary rectifier diodes is generally around {{0}}.7V, and the forward voltage drop of Schottky diodes is even lower. If the soldering iron is powered by power frequency alternating current, the diode in series can play a role in reducing voltage, because the effective value of the voltage will be halved after the alternating current is rectified by the half-wave of the diode. But for the DC voltage, the ideal voltage drop of the diode is only 0.7V at most, and the range of the voltage drop is too small, which has no obvious effect on the temperature drop.
If you want to reduce the temperature significantly, you can only reduce the voltage significantly. There are two ways to reduce the voltage. One is to change the reference voltage of the voltage sampling part of the internal output of the charger. This change method requires certain circuit experience and foundation. Another method is to use a finished DC adjustable step-down module to change the output voltage through a variable resistor. And it can be modified to automatically cool down, and the detection element can be added to the soldering iron stand, and the voltage will be automatically lowered after the soldering iron is put in.
