DC-stroommeting van slimme multimter
①Insert the black test lead into the COM jack, when measuring the current with the maximum value of 200mA, insert the red test lead into the mA jack, and when measuring the current with the maximum value of 20A, insert the red test lead into the 20A jack.
②Set the function switch to the DC current range A-range, and connect the test leads to the load to be tested in series. When the current value is displayed, the polarity of the red test leads will be displayed.
Merk op:
1. Als u het te testen huidige bereik voor gebruik niet weet, zet u de functieschakelaar op het maximale bereik en verlaagt u het geleidelijk.
2. Geeft aan dat de maximale ingangsstroom 200mA is. Overmatige stroom zal de zekering doorbranden en moet worden vervangen. Het 20A-bereik heeft geen zekering en de meting mag niet langer zijn dan 15 seconden.
AC stroommeting
The measurement method is the same as 1, but the gear should be switched to the AC gear. After the current measurement, the red pen should be inserted back into the "VΩ" hole. If you forget this step and directly measure the voltage, the meter or power supply will be scrapped!
